I have some very consistent issues with warping when printing ASA/ABS, which is really annoying since I’m trying to print my voron parts. It’s not warping massively, but enough to mess things up.
I print with these general settings, on a textured PEI flex-plate.
- heated chamber @ 45-47C (can’t go much higher)
- bed temp @105C
- first layer 255C, other layers 245C
- fan off, unless it’s an overhang >=50% or layer time is <10s. Fan maxes out @70% unless bridging.
- speed 200/120 mm/s inner/outer walls
- first layer 50mm/s, 80mm/s infill
I’ve tried both with my regular Z-offset which creates a good uniform first layer, and slightly lower to kind of push it more on to the plate (but worse looking)
- I’ve cleaned the plate with pure IPA
- I’ve tried glue stick
- I’ve tried brim both skirts/mouse ears, which help but don’t eliminate it. (5mm, 0.15mm space)
ABS seems to be a little easier to print than the ASA. I’m using filament from Polymaker
There must be something wrong with contact between traces/solder/connector/wire on this unit. May be many things, but high resistance is basically just a bad contact/too small area of contact.
For instance, one time an SKR board came to me with bed connector not soldered(!) to the board. I didn’t notice for quite some time and have been using it, because the connector was seated strong enough. I noticed only because of the gradual heat damage to the board, and bed heating times getting longer and longer to the point of getting thermal runaway errors. Only then I inspected it in detail.
The other time on another SKR board, the connector was soldered, but slipped out of the solder which was the first time in my life I’ve seen anything like this. The solder cone was correctly formed, but I could slip the connector in and out of it. Guess something was wrong with surfaces of the connectors pins, maybe wrong metal on the outer layer so it didn’t really get wetted by solder, guess I’ll never know. Thankfully I’ve noticed this right before assembly.
Do not trust cheap DIY electronics that are suppossed to run long term unsupervised unconditionally, is what I’m trying to say.