In engineering speak, that’s referred to as “percussive maintenance”.
I had a situation ten or so years ago working on a machine that displayed an error code i didn’t recognize. I looked in the manual, and it had descriptions for error messages like (E1, E2, etc.), but the message was a couple numbers higher than the highest error in the manual (and as a side note, it’s really dumb to program a machine to give an error message without a corresponding key).
I looked through the handwritten old log book for the machine, and found someone referencing the same error code in the early 90’s. The error back then occurred after the machine was moved, but it cleared up after being moved again. We guessed that the issue was a loose connection that got jostled back into place. The machine had just been moved slightly again before our issue, so we assumed it was the same.
We ended up opening the machine, and just poking around until we hit the right wire that reconnected itself and cleared the error message. We wrote that down in the log book as a “digital re-alignment” (digital as in fingers).
In engineering speak, that’s referred to as “percussive maintenance”.
I had a situation ten or so years ago working on a machine that displayed an error code i didn’t recognize. I looked in the manual, and it had descriptions for error messages like (E1, E2, etc.), but the message was a couple numbers higher than the highest error in the manual (and as a side note, it’s really dumb to program a machine to give an error message without a corresponding key).
I looked through the handwritten old log book for the machine, and found someone referencing the same error code in the early 90’s. The error back then occurred after the machine was moved, but it cleared up after being moved again. We guessed that the issue was a loose connection that got jostled back into place. The machine had just been moved slightly again before our issue, so we assumed it was the same.
We ended up opening the machine, and just poking around until we hit the right wire that reconnected itself and cleared the error message. We wrote that down in the log book as a “digital re-alignment” (digital as in fingers).