No problem :) Let me know if you need any help!
No problem :) Let me know if you need any help!
In that case I would omit the extra transistors and use only the optocouplers.
What sort of application is this? Having 18V somewhere and a 5V supply too that can output several amps is quite unusual.
Please don’t use non perpendicular lines and draw in a clearer software if possible. Its quite hard to read.
What is the point of the push-pull BJTs? With the optocoupler you could drive the nmos gates directly. If you need more current to drive the gates (unlikely for a small motor), I suggest you buy dedicated gate drivers. They are tested and not expensive. If you have the 18V available already, using the optocouplers directly would be a lot simpler.
Yes, really. If my move tool is set to layer move, dont change it just because I used the select tool for something completely unrelated. That is the typical dumbed down big colorful button approach that I hate in modern corporate software.
Good idea, I submitted.
I didn’t have too much patience for him, but he was totally sending me to eventviewer!
No, this is the first time something like this happened to me. i dont even get it. In my country mostly young people speak english. Isnt the target demographic the elderly?
Is that from one of these “messing with scammers” videos?
I have seen those, so first I played along a bit. “Oh, these hackers must be very good. Please help me”. But I had things to do so I cut it short.
I never thought one of them would call me. I’m so much outside the target demographic. They might be getting desperate to find targets.
Oh yes. Tethics.
3D printers have obvious and fixable defects. When they break you can see the broken part, you can diagnose and fix it. Regular printers are just fuck you machines.
I do that a lot. I can even correct mistakes before makong them. I imagine doing the motion and realize the angle that I am aiming is not good lr something.
One time I was able to practice serving volleyball without a ball between two sessions and next week I drastically improved.
Have you heard? The release candidate of 1.0 dropped just a few days ago. It looks very interesting.